
SAWDUST / BLOG
Choosing music for an electric car launch
An electric car launch film has a sound problem a petrol car film never had: the product is nearly silent, yet it is designed to make sounds. Choose music after mapping which of those sounds the film should let people hear, then decide where the track carries the picture and where it steps back.
Why is electric car advert music a different brief?
A combustion engine used to do much of the soundtrack's work. The rev, the gear change and the exhaust note told the audience what kind of car this was. An electric drivetrain removes most of that, and the brands themselves have filled the gap with designed sound.
In the United States, the federal safety standard for quiet vehicles (FMVSS No. 141) requires light electric cars, and hybrids that can drive without the engine running, to make an alert sound "at speeds up to 30 km/h (18.6 mph)", with full compliance from 1 September 2019, according to the final rule published in the Federal Register. In the European Union, an acoustic vehicle alerting system "will automatically generate a sound from the start of the car up to the speed of approximately 20 km/h" and when reversing, and it became obligatory in "all new e-cars" from 1 July 2021, as the European Commission announced.
So the car in your launch film probably has a voice of its own at low speed. Manufacturers treat that voice as brand work. BMW had Hans Zimmer work with its acoustic engineer and sound designer Renzo Vitale on the drive sounds for its Vision M NEXT concept, and the BMW Group release from June 2019 quotes Zimmer: "Accelerating becomes an experience during which the driver moves through a series of gradually morphing sound textures." Renault worked with Jean-Michel Jarre and Ircam on pedestrian sounds and a welcome sequence that plays when you sit in the car, and Renault Group's June 2023 story quotes Jarre: "Dwelling in pure silence is a challenge, and exciting."
The brief follows from that. Music for an electric car launch has to share the mix with sounds the client has already paid to design.
What should the music leave room for?
Start by asking the client's product team which sounds exist and which they want heard. A typical list: the welcome or start-up sequence, the low-speed alert sound, interface tones, the door, and the quiet cabin at speed.
Then decide, moment by moment, who leads. When the welcome sequence plays, a busy track will bury it. When the car pulls away below about 20 km/h in the European Union, or 30 km/h in the United States, the alert sound is part of what the car sounds like in the street, so the film can either feature it or cover it, but should do one on purpose. When the cabin is the subject, let it be near-silent and end the music just before that shot.
Tracks built from texture, filtered layers and space, common in underground electronic music, often have a version that thins out cleanly, and a sound designer can sit a tone inside it without fighting a vocal or a dense mix. No genre means "electric" on its own. Judge the rhythm, texture and arrangement against the picture.
What does a music spotting map for a launch film look like?
This is a hypothetical example, not a real campaign. It shows how the team can agree the music's role before anyone auditions tracks.
Time | Picture | Car sound | Music's job |
|---|---|---|---|
0–8s | Driver opens the door, cabin lights rise | Welcome sequence | Hold back, or a single held texture that leaves the sequence clear |
8–20s | Close views of controls and materials | Interface tones | Sparse pulse; leave gaps where the tones land |
20–32s | Car rolls out of a city garage | Low-speed alert sound | Choose: feature the alert sound with music low, or let music take over |
32–48s | Open road, wide exterior shots | Tyre and wind only | Music leads; full arrangement, strongest rhythm |
48–55s | Interior at speed, passenger's face | Near-silent cabin | Pull the track back to one layer, or cut it entirely |
55–60s | Exterior hero shot and end frame | None | Return for the resolve and end frame |
Write the map before the search. A music supervisor or licensing partner can then look for a track whose structure fits it: a quiet opening that can be extended, a clean build into the road section and a section that strips back without collapsing.
How do the short cuts change the choice?
If the plan includes cut-downs for paid social or online video, test the short versions early. As of November 2026, Google describes bumper ads as non-skippable video ads lasting between 5 and 6 seconds, and says that on skippable in-stream ads, "After 5 seconds, the viewer has an option to skip the ad." A six-second cut has no room for a quiet welcome sequence. Start it on the road section.
That changes what you should test before licensing. Check that the track has a point where it can start at full energy without sounding cut off, and that its strongest few seconds still belong to the same car as the 60-second film. If the hero track only works from its quiet opening, the short cuts will need a different edit point or a different piece of music. Find that out at the selection stage, not after the media plan is booked.
When you have a shortlist, the licence needs to cover every cut and channel in that plan. The steps are set out in our guide to how to license a song for a commercial, and what it costs to license a song for an ad explains what moves the fee. For a related launch brief with different sound problems, see choosing music for an AI product launch video.
Working with Sawdust
Sawdust is a music licensing partner for brands, matching underground electronic music to their values, personality and creative direction. If you are mapping the sound of a vehicle launch, tell us about the film and its cuts.
SAWDUST
BASED IN
Singapore
ASK AI ABOUT SAWDUST
© Sawdust 2026